Lander Scanning Tool

The Lander Scanning Tool has been designed to identify the most common errors with the landing page setup. It checks for the following things:

• Page status code: It checks whether your landing page is live or not.
• Click URLs: It checks if click URLs have been implemented on a landing page.
• Redirectless tracking script (if the Redirectless tracking feature was enabled): It checks if the redirectless tracking script has been implemented on a landing page.

In case any of these above checks fail, an error message will appear.

The Lander Scanning Tool is available in the lander form. In order to use it, follow the steps below:

1. Edit or create a new lander.
2. Set up all the required options.

3. Click the Verify landing page button.

   

   Once you click it, Voluum will check your landing page and return one of the following messages:

   • All good: Your landing page has passed all checks and is ready to use.

     

   • Missing direct tracking script: The Direct radio button is enabled and there is no direct tracking script implemented on your landing page. Follow the instructions from the Direct Tracking article to implement it.

     

   • Missing click URLs: No click URLs where detected on your landing page. Follow the instructions from the Adding Click URLs to a Lander article to implement them.

     

   • Missing click URLs and direct tracking script: The Direct radio button is enabled and there are no direct tracking script and click URL(s) implemented on your landing page. Follow the instructions from the Direct Tracking and Adding Click URLs to a Lander articles to learn how to fix that.

     

   • Incorect lander status code: Voluum could not reach your landing page. Verify that it is live and accessible.

     

     Voluum Note: If you use the Lander Protection Script, then the Lander Scanning Tool will not be able to reach your site.